Grass Valley PDR100 - Manual (Page 21)

Additional Configurations
PDR100 Installation 2-5
Serial Digital Component Input/Output
A single Serial Digital Component Input/Output circuit board provides two input and
two output channels. Up to two boards (four video channels) can be installed in any
available slot(s) with connections to the Video Router.
Component Analog Video (CAV) Input
The Component Analog Video (CAV) Input board accepts a single source of
component analog video input. The CAV Input board can be installed in any available
slot that includes connection to the Video Bus (slots that include the Video bus are
slots J5-J16).
Analog Composite Output
The Analog Composite Output circuit board supports up to four channels of video.
Only slots J11 and J12 with four Video Router connections can support these circuit
boards.
Audio Input/Output
Each Audio Input/Output circuit board provides four-channel analog audio input and
output. Up to four Audio circuit boards can be installed in a single PDR100. Audio
circuit boards do not require connection to the Video Router, which also allows them
to be used in slots J3 and J4 (EISA only.) However, they do need to be adjacent to a
Video Input or Output for cabling.
Additional Configurations
Not all of the available configurations of the PDR100 require the addition of circuit
boards; however, in some cases, both circuit boards and external items are part of the
appropriate configuration. For example, adding a monitor requires both an SVGA
monitor along with the installed VGA circuit board.
Keyboard and Mouse
The processor can be controlled externally using a keyboard and mouse.
Monitor (VGA)
Slot J2 is the location of the VGA circuit board. When an SVGA monitor is used, it
is cabled to the D-type connector on the back of the VGA circuit board.
Local Area Network (LAN)
Interface card for access to a local area network. Requires an EISA slot. It should be
installed in J3.