Grass Valley PDR100 - Manual (Page 31)

Mounting the PDR and PDX Units
PDR100 Installation 3-7
Installing the PDR100 or PDX103in the Rack Slides
1. Pull the slide-out track section to the fully extended position. See Figure 3-10.
2. Insert the ends of the cabinet chassis sections into the slide-out sections.
3. Push the cabinet toward the rack until the chassis sections lock into the
intermediate sections.
4. Press the stop latches in the intermediate sections and push the cabinet toward the
rack until the latches snap into their holes.
5. Again press the stop latches and push the cabinet fully into the rack.
6. Tighten the front-panel retaining screws.
Figure 3-10. Rack Slide Stop Latch
Rack Slide Adjustments
After installation binding may occur if the slide tracks are not properly adjusted. To
adjust the tracks:
1. Slide the cabinet out about 10 inches.
2. Loosen slightly the screws holding the tracks to the front of the rails, and allow the
tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding
the cabinet in and out of the rack several times.
4. Tighten the front panel retaining screws once the cabinet is in place within the rack
to complete the installation.
Stop Latch