Grass Valley NV7512 v.1.3 - Manual (Page 94)

84 Rev 1.3 • 10 Oct 08
3. DSP Submodule
Configuring the DSP Sub-Module
5 Check the ‘Enable Crossfade’ check box or the ‘Disable Crossfade’ check box to enable or dis-
able crossfade functions for the selected channels.
6 Click Write Changes to write and save your changes. Changes display in the ‘Select Outputs to
edit’ field.
How to configure phase inversion
The input channels routed to both channels of each output may be independently disabled or
enabled. Output mono mix is expressed by a single bit where 0 = disabled and 1= enabled.
1 Launch UniConfig.
2 From the menu bar, select ‘Window > Audio Adjustment’. The ‘Audio Adjustment’ window
appears, as shown in Figure 3-8.
Figure 3-8. UniConfig Audio Adjustment Window
3 Click the ‘Output’ tab. The tab displays ‘Output’ channel number and if ‘Mono Mix’ (i.e.,
channel summing) is enabled.
4 Click Read Outputs . Outputs information displays in the ‘Output’ tab.
5 In ‘Stereo Selection’ section, select the ‘Single’ radio button for a single input channel or select
the ‘Range’ radio button for a range of input channels.
If ‘Single’ is selected, enter the channel number in the corresponding field.
If ‘Range’ is selected, enter the channel number in the corresponding fields to the right. Enter
the beginning channel number in the left-most field and the ending channel number in the right-
most field.
6 Check the ‘Mono Mix Enabled’ check box to enable channel summing.
7 Click
Read Outputs to display changes on the ‘Inputs’ tab.
8 Click Write Outputs to write and save your changes.