Grass Valley NV7512 v.1.3 - Manual (Page 91)

NV7512 Audio Router • User’s Guide 81
3. DSP Submodule
Configuring the DSP Sub-Module
4 In the ‘Mono Selection’ section, select the ‘Single’ radio button for a single input channel or
select the ‘Range’ radio button for a range of input channels.
If ‘Single’ is selected, enter the channel number in the corresponding field.
If ‘Range’ is selected, enter the channel number in the corresponding fields to the right. Enter
the beginning channel number in the left-most field and the ending channel number in the right-
most field.
5 Enter the ‘Gain’ in the field provided. Gain can be adjusted from -88 dB to 12 dB in increments
of 0.1 db.
6 (Optional) To display each left or right channel of a stereo signal, check the ‘Display Mono as
Physical Connections’ check box, as shown in Figure 3-5.
Figure 3-5. Input Gain Values in UniConfig Audio Adjustment Window - Mono Mode
7 Click Read Inputs to display changes on the ‘Inputs’ tab.
8 Click Write Inputs to write and save your changes.