Grass Valley NV7512 v.1.3 - Manual (Page 93)

NV7512 Audio Router • User’s Guide 83
3. DSP Submodule
Configuring the DSP Sub-Module
How to configure crossfades
Crossfades occur between previously selected output sources and newly selected output sources.
Both channels of each output may be independently disabled or enabled.
1 Launch UniConfig.
2 From the menu bar, select ‘Window > Switch Point Setup’. The ‘Switch Point Setup’ window
appears, as shown in Figure 3-7 on page 83.
Figure 3-7. Switch Point Setup Window
3 Click Read Outputs . Outputs information displays.
4 In the ‘Select Outputs to edit’ field, select the channels for which crossfade functions are being
enabled or disabled. Use the ‘Shift’ key on your keyboard to select several channels at one time.