Grass Valley NV7512 v.1.3 - Manual (Page 90)

80 Rev 1.3 • 10 Oct 08
3. DSP Submodule
Configuring the DSP Sub-Module
Configuring the DSP Sub-Module
After the DSP sub-module is installed, UniConfig must be configured to activate and manage DSP
sub-module functions. When the DSP sub-module is installed, the control card automatically reads
it. However, the router control system cannot read and manage DSP functions until UniConfig is
configured to see the module.
The DSP sub-module enables manipulation of input gain, phase inversion, crossfade and channel
summing. Each of these functions are set up individually in separate UniConfig screens.
How to configure input gain
1 Launch UniConfig.
2 From the menu bar, select ‘Window > Audio Adjustment’. The ‘Audio Adjustment’ window
appears, as shown in Figure 3-4.
Figure 3-4. Input Gain Values in UniConfig Audio Adjustment Window
3 Click the ‘Inputs’ tab. The tab displays current ‘Mono Input’, ‘Gain’ and ‘Polarity’ settings.