Grass Valley NV9654 v.1.1 - Manual (Page 88)

78
Operation
Setup Mode
Panel
Press the ‘Panel’ button to view panel data:
The 5 buttons on the left tell you the panel ID, and other useful information about the panel, in
particular, the panel’s IP address. These are useful in a diagnostic situation. This information
helps you ensure that you are sending the correct configuration file to the correct panel.
 The panel acquires its IP address through DHCP on the NV9000’s panel/router network.
If the ‘Panel ID’ button is high-tally, you may change the panel ID. Normally, only your system
administrator would do that. See
Initialization on page 13 for instructions.
Press ‘Exit’ on the right to return to the menu.
LCD Control
Press the ‘LCD Control’ button to view and change LCD brightness. When you do, the current
LCD button state appears on the 14 top left buttons:
The 14 buttons occur in pairs — one pair for each defined color. The pair shows the high tally
and low tally values for the particular color.
You can change high-tally from high to medium brightness and change low tally to medium or
low brightness, as long as high tally is brighter than low tally. (They cannot both be medium, for
instance.)
To change a color’s brightness, select the button for the color you want to change. Press either
the ‘Make Color Lighter’ button or the ‘Make Color Darker’ button, whichever is available.
If you make a change, press ‘Save’ to commit the change or press ‘Cancel’ to discard the change.
If you have made no changes, just press ‘Exit’ to return to the menu.
The actual colors cannot be represented accurately in print or in a PDF file displayed on your
screen. There is a small amount of variation in color from button to button. See
LCD Buttons on
page 93 for a color chart.
Setup Mode
Setup mode occurs when the NV9654 is disconnected from its network and is freshly powered
up. In setup mode, you can set or change the panel ID, determine software versions, and
perform a test of the panel’s buttons. It is in setup mode that you must initially set the panel ID.
Panel Panel
ID ID
6541 6541
Panel Panel
Name Name
D654 D654
IP Addr IP Addr
192.168. 192.168.
100.44 100.44
SVR_NAM SVR_NAM CFG CFG
File File
D654 D654
• • •
EXIT EXIT
LCD HI LCD HI
GREEN GREEN
HIGH HIGH
LCD LO LCD LO
AMBER AMBER
LOW LOW
LCD HI LCD HI
BLUE BLUE
HIGH HIGH
LCD HI LCD HI
BLUE BLUE
HIGH HIGH
LCD LO LCD LO
GREEN GREEN
LOW LOW
LCD HI LCD HI
AMBER AMBER
HIGH HIGH
LCD HI LCD HI
YELLOW YELLOW
HIGH HIGH
LCD HI LCD HI
RED RED
HIGH HIGH
LCD LO LCD LO
RED RED
LOW LOW
LCD LO LCD LO
YELLOW YELLOW
LOW LOW
LCD HI LCD HI
PURPLE PURPLE
HIGH HIGH
LCD LO LCD LO
PURPLE PURPLE
LOW LOW
LCD HI LCD HI
GREY GREY
HIGH HIGH
LCD LO LCD LO
GREY GREY
LOW LOW
EXIT EXIT
MAKE MAKE
COLOR COLOR
BRIGHTER BRIGHTER