Grass Valley NV9654 v.1.1 - Manual (Page 83)

73
NV9654
User’s Guide
Definitions
Owner The user ID of a panel where a lock or protect was issued.
Source lock No one can use the source.
Source protect No one but the owner can use the source.
Destination lock No one can route to the destination.
Destination protect No one but the owner can route to the destination.
Release To remove a lock or protect.
Some control panels can lock or protect both sources and destinations. However, The NV9654
provides locks and protects for destinations only.
A forced release is when the lock or protect is removed by someone other than the owner. A
forced release can be performed:
• At any panel configured with release mode set to “forced release”.
• At any other panel with “force release” enabled.
The ‘Destination Lock’ and ‘Destination Protect’ buttons are toggles. Press the lock (or protect)
button to lock (or protect) a destination. Press the button again to release the lock (or protect).
Takes
Following are brief instructions on how to perform a take in 3 scenarios.
XY Mode
1 If required, enter X-Y mode. (Use the XY/MD button.)
2 If required, select a destination.
3 Optionally choose levels.
4 Select a source and press ‘Take’.
OR
5 Select a quick source. The take is automatic.
Single-Destination Panel
(This scenario assumes that a destination was pre-selected during configuration.)
1 Select a source and press ‘Take’.
OR
2 Navigate to a quick source, and select it. The take is automatic.
MD Mode
1 If required, enter MD mode. (Use the XY/MD button.)
2 Scroll to a destination and select it.
3 Select a source.
4 Repeat steps 2 and 3 for all destinations you intend to use.
5 Press ‘Take’.