Grass Valley NV9654 v.1.1 - Manual (Page 78)

68
Operation
Operating Concepts
Quick source and source buttons are similar, except that the quick source performs a take. Be
aware of which buttons are quick sources so you do not perform an accidental take.
Normally, the button text is the source’s mnemonic, but the configurer can assign any text to the
button.
Salvo
This button executes a system salvo. A salvo is a pre-defined sequence of NV9000 commands.
The button text is the salvo name. When you press the salvo button, the panel temporarily
enters “salvo” mode and presents a message similar to this one on the display:
To confirm that you want to execute the salvo, press a ‘Take’ button. (You might have to navigate
to a ‘Take’ button.) When you press the take button, the salvo begins executing immediately.
Salvos are typically short in duration.
If you want to cancel the salvo before it executes, press the salvo button again.
System salvos are defined in NV9000-SE Utilities. You can review the defined salvos in NV9000-
SE Utilities or communicate with the panel’s configurer regarding the function of any salvos in
your panel configuration.
Save Preset
This button is a toggle: it enables or disables “save preset” mode. When this function is enabled
(and the button is high tally), whatever is on preset is retained on preset after a take. When the
function is disabled (its button is low tally), whatever is on preset is discarded after a take.
The default button text is “Save Preset” but the button can have any legend.
Selection Buttons
In X-Y mode, the display (if it is present) shows the levels of the current destination. Selection
buttons (if present in the current button page) represent individual levels and allow operators to
select or deselect levels. The selection buttons themselves show the preset source and current
source for each level.
In MD mode, the display (if it is present) shows MD devices. Selection buttons (if present in the
current button page) represent individual MD devices and allow operators to select or deselect
MD devices. The selection buttons themselves show the indivdual MD device names and the
current and preset sources for each device. If there is no preset device, that line of text is blank.
A selection button is high-tally when its associated level or MD device is selected and low-tally
otherwise.
Salvo
Execute
SD-Setup
Press
Take
SD-Setup * Salvo Name