Grass Valley 2200 - Manual (Page 26)

3-2
Section 3 Ð Editor Interface Commands
The appropriate command to use may be determined as follows:
For basic crosspoint control use:
¥ Crosspoint Bus (C1) Command (PGM/BKGD A/AUX) on page 3-6
¥ Crosspoint Bus (C2) Command (PST/BKGD B) on page 3-8
¥ Crosspoint Bus (C3) Command (KEY 1/DSK 1) on page 3-9
¥ Crosspoint Bus (C4) Command (KEY 2/DSK 2) on page 3-10
¥ Crosspoint Bus (E2) Command (PVW) on page 3-11
¥ Crosspoint Bus (E3) Command (MASK) on page 3-12
¥ Write Split Key (E4) Command on page 3-38
Select Wipe Patterns by using:
¥ Write Wipe Pattern (C8) Command on page 3-21
Control the Transition mode pushbuttons by using:
¥ Write Transition Mode (CA) Command on page 3-23
Set transition rates by using:
¥ Write Auto Transition Rate (CC) Command on page 3-27
¥ Write Key Transition Rate (CD) Command on page 3-29
To simulate the pressing of buttons on the transition subpanel use:
¥ Pushbutton Select and Control (C6, C7 and FB) Commands on page 3-13
For E-MEM learns and recalls use:
¥ Write Learn E-MEM Register (DA) Command on page 3-35
¥ Write Recall E-MEM Register (DB) Command on page 3-31
For E-MEM and ConÞguration Data transfer use:
¥ Data Transfer (5E and DE) Commands on page 3-41
To control the timeline for multiple keyframe effects use:
¥ Timeline Control (4E, 4F, CE, and CF) Commands on page 3-52
To simulate pressing buttons on the timeline run control subpanel use:
¥ Pushbutton Select and Control (C6, C7 and FB) Commands on page 3-13
For general use by an editor, the following commands are provided:
¥ ALL STOP (F2) Command (Version 5.1 and Later) on page 3-5
¥ Software Version (6C and EC) Commands on page 3-50
¥ Select ÒLayeredÓ Or ÒStandardÓ (E8) Command on page 3-40