Grass Valley Kayak HD v.6.9.3 - Manual (Page 536)

536 Kayak — User Manual
Section 7 — Sidepanel Menu Summaries
Replace Async: The Modify button permits the selection of different
modes for the treatment of asynchronous sources in the
switching levels (M/E1, M/E2, P/P):
On: If Background/Program are asynchronous, enabled
keyers are disabled. If Background/Program are asyn-
chronous and the fill signal of a keyer becomes asynchro-
nous, the enabled keyer is disabled. If Background/
Program or Preset are asynchronous and a transition is
selected, a cut is performed at the end of the transition.
Off: Asynchronous signals are phased over H and are
passed.
AUX Preview Bus: Selecting the desired AUX Preview Bus None, Aux1 ...
Aux15
Auto AUX Preview: Enable or disable the Auto PVW mode. In enabled condi-
tion the key PVW, mask PVW or the chroma key cursor
signal of the respective mixing level is switched on the
PVW bus.
KeyMemory
AutoSave: If the KeyMemo button is switched on in a Keyers menu,
the key memory is always recalled if the key sources are
changed during control panel operation. These changes
can occur directly by selecting another key source or also
indirectly by changing the Fill source or the Split mode.
For storing the key settings in the key memory two
modes are available:
Auto Save: If the switch Key Memory AutoSave=On, the
settings of the previous key signal are stored automati-
cally before the settings of the next key are recalled. If the
switch Key Memory AutoSave=Off, the stored settings of
the new key are recalled without saving the previous set-
tings.
Manual Storing: Key Memory AutoSave=Off. For storing
the current settings into the key memory, press the
button of the respective Fill source approximately 2 sec-
onds. The storing is confirmed by a short beep in the
control panel.
Half ME Mode Selects the Half-ME mode: Normal ME or DSK mode
Half ME Keyers
coupled to Delegates the keyer to ME1, ME2, ME3 or PP