Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 - Manual (Page 96)

96 Kameleon HD Instruction Manual
Initial Configuration Process Overview
• Frame Health Reporting – this section provides a table showing the
presence and status of all frame devices such as modules, power
supplies, and fans and other frame functions such as Module
Health and Frame Bus status. Use the corresponding
Report check-
boxes to indicate which alarms and warnings should be reported to
the Frame Health alarm for the following conditions:
• Faults
• Signal Loss
• Reference Loss
• Config Error
• SNMP Trap Reports Link – select the SNMP Trap Reports link to open the
2000NET SNMP Reporting web page. This link will only be present
when SNMP Agent software has been installed on the 2000NET
module. This web page allows configuration of what alarms and warn-
ings that are reported to the SNMP management software.
• Hardware Switch Status – the Hardware Switch Status section of this
web page displays the current settings of the alarm and warning
configuration DIP switches, S1 and S2, on the 2000NET circuit
board in this frame. These switches allow enabling and disabling of
the overall status reporting information provided to the SNMP
traps.
Note Slot SNMP traps can be enabled only when the hardware switches for Module
Fault reporting and Asynchronous Status reporting are in enabled on the
2000NET module (dipswitch S1 segment 7 and dipswitch S2 segment 1).