Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 - Manual (Page 79)

Kameleon HD Instruction Manual 79
Initial Configuration Process Overview
SD Video Proc Web Page
The SD Video Proc web page ( Figure 62 ) provides overall video processing
for a down converted HD signal or an SD input type signal when in SD
mode. The SD Video Proc is enabled or disabled on the
System Config Web
Page on page 43 with the Video Proc Amps Enabled/Disabled control or a color
bars signal (not adjustable) can be enabled and sent to the output. Proc
Amp status is reported in the lower left of the SD Video Proc header.
Use the following controls to make adjustments to the SD video output:
• Y/Cb/Cr Gain – Set the gain for the Y, Cb, or Cr channel from 0 – 200% (total
effective Y Gain will reach approximately 188%) with the corre-
sponding control or lock the controls together by checking the
Video Gain Lock checkbox and adjust any one of the gain controls.
• Y/Cb/Cr Offset – Set the offset ± 100% for the Y, Cb, and Cr channels with
the corresponding control.
• Hue – adjust the output hue from – 180 to + 179 degrees.
Figure 62. SD Video Proc Web Page
Use
this
link