beautypg.com

Cabling, Serial or hd sdi video input, Video outputs – Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 User Manual

Page 15: Composite outputs, Fiber if

background image

Kameleon HD Instruction Manual

15

Installation

Cabling

All cabling to the Kameleon HD module is done on the corresponding
KAM-HD-R Rear module for the KAM-HD-FS and KAM-HDD modules
(

Figure 7 on page 16

) or the dual height KAM-HDD-R Rear module

required for the KAM-HDD-PA and KAM-HDD-FS modules (

Figure 8 on

page 16

) at the back of the 2000 frame. There are a number of different input

and output configurations possible depending on system configuration
and module type.

To determine the correct cabling for your application, refer to

System Con-

figuration

on page 43

and the

I/O Config Web Page

on page 37

.

Serial or HD SDI Video Input

Connect an SD or HD SDI video input to BNC connector J10, labeled

V1

.

Video Outputs

There are four SDI video outputs at BNC connectors J1 J3, J4, and J9 labeled

SDO

. BNCs J3 and J4 are configurable as HD or SD in System Configuration

(

page 43

) on modules with down conversion capability.

Composite Outputs

On the KAM-HDD or KAM-HDD-FS modules when the input type is SD
or HD 59.94 or HD 50 (supporting down conversion), composite outputs
become available on BNCs J6 and J7. Connect these to composite destina-
tions.

Note

KAM-HDD/-PA/-FS modules with an HD 24 video input do not support down
conversion.

Fiber IF

This connection is for future use and currently not used.