Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 - Manual (Page 11)

Kameleon HD Instruction Manual 11
Installation
Installation
Installation of the Kameleon HD module is a process of:
• Placing the rear module in a rear frame slot,
• Placing the media module in the corresponding front slot, and
• Cabling and terminating signal ports.
The Kameleon HD module can be plugged in and removed from a 2000
Series frame with power on. When power is applied to the module, LED
indicators reflect the initialization process (see
Power Up on page 17 ).
Note The Kameleon HD must be installed in a 2000T1DNG or 2000T3NG frame
(2000NET and 2000GEN module installed) for access to a frame reference.
Module Placement in the 2000 Frame
There are twelve slot locations in both the front and rear of a Kameleon
3 RU frame to accommodate Kameleon HD modules. The KAM-HD-FS
and KAM-HDD module set consist of a front media module and a single
height KAM-HD-R Rear module allowing up to 12 modules per 3 RU
frame, 4 in a 1 RU frame. The KAM-HDD-FS and KAM-HDD-PA require a
dual height rear KAM-HDD-R Rear module that uses two rear module
slots allowing up to 4 modules per 3 RU frame, 2 in a 1 RU frame.
Dual-height modules can be placed in any rear slot as long as there is room
in the frame.
To install a Kameleon HD module set in a 2000 Series frame:
1. Locate a vacant slot in the rear of the 3 RU frame ( Figure 1 ) or the
2000T1DNG frame ( Figure 2 on page 12 ).
Figure 1. 2000T3NG Frame, Rear View
Media section
rear slots 1-6
(with one 2000EMI blank)
Media section
rear slots 7-12
Network
and reference
input connections
Power, frame
configuration,
& frame health
connections
8341_12r1