Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 - Manual (Page 73)

Kameleon HD Instruction Manual 73
Initial Configuration Process Overview
HD Video Proc Web Page
The HD Video Proc web page ( Figure 58 on page 74 ) is present when an HD
input type is selected on the System Config web page. It provides overall
video processing for the HD output signal.
Note The internal Color Bars test signal is not adjustable with the proc amp.
The HD Video Proc is enabled or disabled on the System Config Web Page on
page 43 with the Video Proc Amps Enabled/Disabled control. Proc Amp status
is reported in the HD Video Proc web page header.
The HD Video Proc provides the following controls:
• Y/Cb/Cr Gain – Set the gain for the Y, Cb, or Cr channel from 0 – 200% (total
effective Y Gain will reach approximately 188%) with the corre-
sponding control or lock the controls together by checking the
Video Gain Lock checkbox and adjust any one of the gain controls.
• Y/Cb/Cr Offset – Set the offset ± 100% for the Y, Cb, and Cr channels with
the corresponding control.
• Color Saturation – set the overall color saturation (chroma gain) from
0 – 200%. (This setting will affect Cb and Cr gain slightly.)
• Hue – adjust the output hue from – 180 to + 179 degrees.
• Split Screen – use a horizontal or vertical split screen to compare the
unprocessed input video (top or right) to the processed output video
(bottom or left). Enable the split screen by checking the Split
Enabled
checkbox.
Use the Position control to set the amount of horizontal or vertical split
(10 to 90%) of unprocessed video to appear on the screen.
This control is the same as the other Split Screen controls on the Color
Correction, SD Video Proc, and System Config web pages.
Use
this
link