beautypg.com

Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 User Manual

Page 86

background image

86

Kameleon HD Instruction Manual

Initial Configuration Process Overview

Composite Out Web Page

The Composite Out web page (

Figure 68 on page 87

for 525 line rate and

Figure 69 on page 88

for 625 line rate) is present when the module has

down conversion capability (KAM-HDD-PA and KAM-HDD-FS with HD
59.94 or HD 50 video input or an SD video input).

The Composite Out web page provides the following controls for adjusting
the composite video output:

Output Video

– enable the following output components in the composite

video output by checking the

Enabled

checkbox:

Signal Setup

– (525 line rate only) enable or disable setup on the com-

posite output signal.

Burst

– enable or disable burst on the composite output signal.

Chrominance Signal

– enable or disable chrominance on the composite

output signal.

Output Video Adjustment

– select the

Calibrated

radio button to output

factory calibrated values or the

User Adjustable

radio button to enable

the Luma Gain, Chroma Gain, Black Level, and Hue (525 only) com-
posite output controls on the right side of the web page display
inside the dashed lines in

Figure 68 on page 87

and described

below. For factory default values, refer to

Table 3 on page 19

.

Output Video Gain

– adjust the overall output gain of the composite

video.

Delay Coarse

– adjust the coarse delay of the video output in

half-pixel increments.

Output Video Adjustment - User

– when the User Adjustable radio button is

selected, the following output video controls become enabled:

Luma Gain

– adjust the percentage of luma gain relative to 100% on

the composite output signal.

Chroma Gain

– adjust the percentage of chroma gain relative to 100%

on the composite output signal.

Black Level

– adjust the percentage of black relative to 0 (zero) on the

composite output signal.

Hue

– (525 line rate only) adjust the hue in degrees on the composite

output signal as needed.

Use
this
link