beautypg.com

Initial configuration process overview – Grass Valley Kameleon HD Multi-Function Modules v.2.1.0 User Manual

Page 31

background image

Kameleon HD Instruction Manual

31

Initial Configuration Process Overview

Initial Configuration Process Overview

To configure the Kameleon module proceed as follows:

1.

Go to the I/O Config web page (find the applicable module
configuration starting on

page 37

) to name inputs and outputs.

2.

Go to the System Config web page (find the applicable module
configuration starting on

page 43

) to configure the input video type

(HD or SD), the video input rate, and the output timing source; and for
modules supporting down conversion, BNCs J3 and J4 as SD or HD
outputs. Split Screen controls are also available on this page as well as
on the HD Video Proc, SD Video Proc, and Color Correction web pages.

3.

If not already connected, connect all input and output signals and
verify component and signal presence and condition on the Status web
page (

page 35

).

4.

Go to the Functional View web

page (find the applicable module

configuration starting on

page 56

) to use the block links to configure

each function in turn. Video processing must be enabled on the System
Config web page or with the Newton control panel.

Note

Next, Functional View, and Back links are provided to help you navigate
through a logical configuration sequence.

5.

Use the Slot Config web page (

page 94

) to assign Slot Configuration

information such as slot name and asset number. Also link to the
2000NET module web pages to enable and disable Frame Health and
SNMP trap reporting.

6.

Use E-MEM memory (

page 89

) to store or recall configurations as

necessary.

7.

Go to the Software Update web page (

page 98

) for information on

updating software.