Grass Valley KAM-ENC-2AES v.4.0.1 - Manual (Page 53)

KAM-ENC-2AES Instruction Manual 53
KAM-ENC-2AES Links and Web Pages
Audio Processing Web Page
Use the Audio Proc web page ( Figure 32 on page 54 ) to adjust the following
for each audio pair:
• Adjust audio signal gain for each individual channel or the two audio
pairs,
• Lock gain settings for simultaneous channel A/channel B adjustment,
• Select a processing option for each channel, and
• Select output resolution for each output pair.
Audio Gain
Each audio channel can be adjusted for gain separately or in pairs. Use the
following adjustments for audio gain:
• To lock the two channels in a pair together, select the Gain Settings
Locked checkbox for Pair 1 and/or Pair 2.
• Adjust the gain (-40 to +6 dB) for each channel with the Ch A Gain
Adjust and Ch B Gain adjust controls for each pair. If the pair is locked,
adjusting either control will set the gain to the same value for each
channel in the pair.
Note After gain has been adjusted, a straight quote mark (') will be added to Ch A'
and Ch B' to indicate the status of the channels after gain.
Output Processing
Set the output processing for each channel with the Processing pulldown
to one of the following:
• Pass
• Invert
• A+B
• A-B
• -(A+B)
• 1 kHz (test tone)
• 400 Hz (test tone)
• Silence
The Presence and Clipping status of each audio channel is reported as True
or False in the read-only displays. If the audio is > -40 dBFS, it will be
reported as True . If clipping is < 0.5 dBFS, it will be reported as False as
shown in Figure 32 on page 54 .
Use
this
link