beautypg.com

View selection, Video selection settings, Output timing selection – Grass Valley KAM-ENC-2AES v.4.0.1 User Manual

Page 35

background image

KAM-ENC-2AES Instruction Manual

35

KAM-ENC-2AES Links and Web Pages

View Selection

In the View Selection display, choose the

Standard

radio button to display

the standard settings shown in

Figure 17 on page 34

. Use the

Advanced

view

for configuring the Vertical Blanking Interval for selecting active video
lines to carry data (see

Advanced VBI Configuration on page 36

).

Video Selection Settings

The following functions are provided in the Video Selection section in both
the Standard and Advanced views:

Input Name – (read-only) signal name is entered on the

I/O Config

web

page

Input Status –

Signal presence reported

Enable/disable Loss of Signal report to both Kameleon status web
pages and SNMP monitoring devices.

Note

The disabling of video and reference Loss of Signal reports and SDI Input
Error warnings allow you to filter reports from higher level Kameleon status
displays and SNMP monitoring. They will still be reported on this web page.

Video Format – current input video format reported.

Video Line Rate – select 525 or 625 line rate or enable automatic line rate
detection

Frame Reference –

2000GEN frame reference signal presence reported,

Enable/disable Loss of Signal report to both Kameleon status web
pages and SNMP monitoring devices.

SDI Input Errors –

Input signal errors reported, and

Enable/disable SDI error warning report to both Kameleon status
web pages and SNMP monitoring devices.

Frame Sync/Delay – (read-only) Frame Sync mode is reported when
Output Timing Selection is

Internal

Frame Reference

and timing is pro-

vided from the 2000GEN module. Frame Delay mode is reported when
the input signal (

Video In

) is used for timing reference.

Output Timing Selection

The 2000GEN reference module must be installed in the frame and for the
Kameleon to work as a frame synchronizer, set the output timing source to

Internal

Frame Reference

. Otherwise, set the output timing source to

Video In

.

This manual is related to the following products: