beautypg.com

Output video adjustments, Composite out web page – Grass Valley KAM-ENC-2AES v.4.0.1 User Manual

Page 46

background image

46

KAM-ENC-2AES Instruction Manual

KAM-ENC-2AES Links and Web Pages

Composite Out Web Page

Use the Composite Out web page (

Figure 27 on page 47

for calibrated

adjustment and

Figure 28 on page 48

for user adjustment) to set parameters

for the composite video output on the module as listed below:

Select the

Setup

or

No Setup

radio button to add or not add setup on the

525 composite outputs,

Enable or disable the following by selecting the corresponding radio
button:

Cross Color Removal

– enabling this control filters our unwanted lumi-

nance and chrominance artifacts produced during encoding.

Chrominance Signal

– enable this control to completely remove the

chrominance portion of the composite output signal.

Burst Signal

– enable this control to completely remove the burst

portion of the composite output signal.

Output Video Adjustments

The following output video adjustments can be made for gain and
coarse/fine delay of the composite output signal when the

Calibrated

radio

button is selected (

Figure 27 on page 47

). The delay settings are indepen-

dent of the Frame Sync controls.

Delay Coarse

– adjusts the output delay in coarse steps of 5 pixels (double

arrows) or 0.5 pixels (single arrows). The coarse delay range is from 0 to
4095 pixels.

Delay Fine

– adjusts the percent of output delay in fine steps of 10 percent

(double arrows) o r1.0 percent (single arrows). The fine delay range is
from 0 to 100% (100% = 37-38 ns)

Output Video Gain

– adjusts the output video gain in steps of 5 percent

(double arrows) or 0.5 percent (single arrows). The output gain range is
approximately 61to 138.5 percent.

Use
this
link

This manual is related to the following products: