Grass Valley SiteConfig Migration Instructions - Manual (Page 51)

The Add Device dialog box opens.
2. Configure settings for the device you are adding as follows:
• Family – Select System Management .
• Type – Select ControlPoint PC .
• Model – Select Control Point PC .
• Name - This is the device name, as displayed in the SiteConfig device tree view
and device list view. You must configure this name to be the same as the host
name on the actual control point PC.
• Amount – Leave this setting at 1 . Do not attempt to configure multiple control
point PC simultaneously.
• Control Network – Select the control network.
• Starting Address – Select the IP address that is the address currently configured
on the actual control point PC.
3. Click OK to save settings and close.
Verify that IP settings for the placeholder device's control network interface are
identical to those on the actual control point PC before using SiteConfig to discover
the control point PC on the control network.
Assigning the control point PC
Prerequisites for this task are as follows:
• The SiteConfig control point PC has the "SiteConfig Network Configuration
Connect Kit" installed.
• The system description contains a control point PC placeholder device.
• The placeholder's control network interface is configured with the control network
IP address that is currently on the actual control point PC.
02 July 2009 SiteConfig Migration Instructions 51
Discover and assign devices