Grass Valley SiteConfig Migration Instructions - Manual (Page 30)

• The DiscoveryAgent Setup folder contains the ProductFrame Discovery Agent.
You can copy the contents of this folder to a device and then run setup.exe to
install the software.
Installing SiteConfig support
Do the following to verify and, if necessary, install SiteConfig support software so
that the device can be discovered and managed by SiteConfig.
1. Open the Windows Services Control Panel and look for the following required
item:
• ProductFrame Discovery Agent
2. Open the Windows Add\Remove Programs Control Panel and look for the following
required item:
• Microsoft .NET Framework 2.0 Service Pack 2
3. Proceed as follows:
• On Aurora Edit, Aurora Share, Aurora SmartBins, Aurora FTP, and Aurora
Conform Server devices, if the ProductFrame Discovery Agent is installed, use
the Windows Add\Remove Programs Control Panel and uninstall it. On these
devices you must uninstall and then install version 1.1 or higher, as instructed
in next steps.
NOTE: The Discovery Agent can be named the ProductFrame Discovery
Agent, the SiteConfig Discovery Agent, or the SiteConfig Network
Configuration Connect Kit.
• On other devices, if the ProductFrame Discovery Agent is already installed,
you can leave it installed as is.
• On all devices, if either the ProductFrame Discovery Agent or .NET is not
installed, install the required software as instructed in next steps.
4. Navigate to your SiteConfig files or to the SiteConfig install location.
5. To install the ProductFrame Discovery Agent Service do the following:
a) Copy the Discovery Agent Setup subdirectory to the device.
b) In the Discovery Agent Setup directory, double-click the
DiscoveryAgentServiceSetup.msi file.
The setup program launches to install the SiteConfig Discovery Agent.
c) Follow the setup wizard.
The setup wizard presents a list of devices types similar to the following:
• K2Server
• GigESwitch
• FCSwitch
30 SiteConfig Migration Instructions 02 July 2009
Evaluate and prepare devices for SiteConfig