Grass Valley Apex v.2.0 - Manual (Page 96)

98 APEX — Installation and Service Manual
Section 3 — Installation
Figure 41. DIP Switch Settings on CX-34000 Control Crosspoint Board
AES ("locked") mode =
Mono mode =
2-level stereo mode =
S34-8 must be set to ON for APEX PLUS systems.
= Apply settings of S28 5-8 to all “Output cards” and
apply settings of S30 7-8 to all “Input cards” (MADI).
Apex Plus must use this setting .
= Standard Apex: Enable all “Output Card”
switches and all “Input Card” (MADI) switches.
On
If S34-8 is set to ON, settings for Chassis 0
Output Card 0 (S28 5-8) will apply to all “Output
Cards”, and settings for Chassis 0 Input Card 0
(S30 7-8) will apply to all “Input Cards” (MADI).
Standard Apex only: If S34-8 is set to OFF,
REF and VFADE can be set on a card-by-card basis.
V-fade Off
V-fade Off
V-fade Force On*
(not recommended)
V-fade Auto*
AES REF B
VID REF B
AES REF A
VID REF A
*Requires a video reference
to be selected for this card.
V-fade not available for Apex Plus.
AES REF B
VID REF B
AES REF A
VID REF A
Mono mode =
On
OUTPUT CARDS
On
INPUT CARDS (MADI)
S28 S30
---- MADI ----