Grass Valley Apex v.2.0 - Manual (Page 117)

APEX — Installation and Service Manual 119
Reset Procedures
Reset Procedures
• Individual boards can be reset by pulling and re-seating them (power
can be left on); this will cause the system to be reconfigured from the
CL-34000 License board. Depending on the board being reset, this may
cause an interruption to one or all signals. The duration of this interrup-
tion depends on the size of the system.
• All boards in a chassis can be reset by pressing switch S1 located on the
top of the CL-34000 License board. This is a small round black push
button mounted so that it is accessible without removing the board (see
Figure 53 ).
CAUTION Pressing this switch will reconfigure all boards in the system and cause an
interruption to all signals. The duration of this interruption depends on the
size of the system.
Figure 53. CL-34000 License Board RESET Switch
• Alternatively, all boards in a chassis can be reset by cycling power,
either by removing the power cord(s), or pulling and re-seating the
power supply(s). This will reconfigure all boards in the system and
cause an interruption to all signals. The length of this duration depends
on the size of the system.
RESET SWITCH
U2