Grass Valley Apex v.2.0 - Manual (Page 56)

58 APEX — Installation and Service Manual
Section 2 — Planning Guide
CC-2010 Matrix (Crosspoint Bus) Cable
Connection from a Jupiter VM-3000 or CM-4000 System Controller is via a
Crosspoint bus cable, which can be supplied in 3, 10, 25, or 50 foot lengths.
In multi-frame systems, the Crosspoint bus is connected only to the chassis
containing the CX-34000 Control Crosspoint board(s). For this reason, a
CB-3000 Control Buffer is not required for expanded systems.
The CC-2010 is a 10-conductor (plus ground) cable. Ready-made cables,
with installed 15-pin D male connectors, are available from Thomson Grass
Valley (see
page 69 ).
All rear-panel Crosspoint bus connectors are 15-pin D, female.
Installation details for Crosspoint bus cables are shown in Figure 52 on
page 111 .
Jupiter Control System Planning
Refer to the Jupiter VM-3000 System Controller Installation and Operation
Manual, part number 0718305xx or the Jupiter CM-4000 System Controller
Installation and Operation Manual, part number 0718261xx for control
system planning information.