Level – Grass Valley Apex v.2.0 User Manual
Page 105
APEX — Installation and Service Manual
107
Jupiter Control
2.
Set Level switches:
Two back-panel rotary switches shown in
are used to set the
level address of the router.
Figure 50. Level Switches
For Jupiter VM-3000 control
:
Super
Crosspoint bus settings must be used.
The left-hand switch is turned to the appropriate most significant bit on
the
Super
side of the switch; the least significant bit is set on the right
switch. For example, to set the switcher level at
32
(the factory default
for serial digital video) the left switch would be set at
Super 32
and the
right switch set to
0
.
Note
Systems larger than 512x512 cannot be controlled by VM-3000.
For Jupiter CM-4000 control:
Either
Super
or
Ultra
Crosspoint bus settings can
be used; however, systems larger than 512 x 512 must use
Ultra
Cros-
spoint bus settings. For these settings, the left-hand switch is turned to
the appropriate most significant bit on the
Ultra
side of the switch; the
least significant bit is set on the right switch. For example, to set the
switcher level at
32
(the factory default for serial digital video) the left
switch would be set at
Ultra 32
and the right switch set to
0
.
3.
For synchronous switching on all outputs, the same sync signal must be
sent to the Jupiter and to the Apex.
4.
Connect the Status LAN as required. See
5.
Refer to the Jupiter VM-3000 System Controller Installation and
Operation Manual, part number 04-045707-002 or the Jupiter CM-4000
System Controller Installation and Operation Manual, part number
0718261xx for control system installation details.
LEVEL
SUPER
ULTRA
0
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14 15
16
16
32
32
48
48
64
64
80
80
96
96
112
112