Settings web page – Grass Valley 8943CF User Manual
Page 48
48
8943CF — Instruction Manual
Configuration and Monitoring
Settings Web Page
Use
this
link
Use the Settings web page (
) set the input operating
mode for each channel, enable the fiber optic outputs, and monitor the rate
detected and signal state for each channel.
Inputs
Select the input operating mode for each channel by selecting a mode from
the channel pulldown from one of the following choices:
•
Auto Reclock/Bypass mode
•
Auto Reclock/Mute mode
•
3G 2970M mode
•
HD 1485M mode
•
SD 270M mode
•
Manual Bypass HD/3G
•
Manual Bypass SD
Each of the operating modes are described in detail in Input Operating
Modes Overview
Outputs
Enable the fiber optic outputs by selecting the checkbox next to the trans-
mitter output. Two CWDM transmitter SFP devices must be installed
before all fiber outputs will be available.
Note
As shown in
at the bottom of the web page, if on-board
jumper J13 is set to disable the fiber outputs, a warning message will appear
at the bottom of the outputs section.
Set Defaults
Use the
Set Defaults
button at the bottom of the page to recall factory
defaults, Input Reporting Enabled and Auto/Mute mode, for each channel.