Sd 270m mode, Manual bypass hd/3g mode, Manual bypass sd mode – Grass Valley 8943CF User Manual
Page 33
8943CF — Instruction Manual
33
Configuration and Monitoring
SD 270M Mode
In this mode, the electrical inputs are equalized and fed to the reclocker. If
the bit rate is analyzed as 270Mb/s (SD), the module will reclock the signal
at the determined bit rate and feed this signal to both the electrical BNC and
the fiber optic outputs. With input reporting enabled, the input signal will
be reported as
Present
.
If no input signal or a signal other than 270Mb/s is detected by the module,
the output of the reclocker will be muted and the outputs will be static
(muted). With input reporting enabled, the signal input will be reported as
Not Present
.
Manual Bypass HD/3G Mode
In this mode, the electrical inputs are equalized and fed to the reclocker.
The bit rate is analyzed by the module. If the bit rate is analyzed as
1485Mb/s or 2970Mb/s, the module will reclock the signal at the deter-
mined bit rate and feed this signal to the both the electrical BNC and the
fiber optic outputs. With input reporting enabled, the input signal will be
reported as
Present
.
If a bit rate other than 1485Mb/s or 2970Mb/s is detected by the module or
no input signal is detected, reclocking will not be performed and the signal
will be automatically bypassed to the outputs. With input reporting
enabled, the input signal will be reported as
Not Monitored
.
Manual Bypass SD Mode
In this mode, the electrical inputs are equalized and fed to the reclocker.
The bit rate is analyzed by the module. If the bit rate is analyzed as
270Mb/s, the module will reclock the signal at the determined bit rate and
feed this signal to the both the electrical BNC and the fiber optic outputs.
With input reporting enabled, the input signal will be reported as
Present
.
If a bit rate other than 270Mb/s is detected by the module or no input signal
is detected, reclocking will not be performed and the signal will be auto-
matically bypassed to the outputs. With input reporting enabled, the input
signal will be reported as
Not Monitored
.