Grass Valley 8943CF - Manual (Page 21)

8943CF — Instruction Manual 21
Installation
6. Insert the simplex ends of the fiber cable assembly (the two fiber optic
connectors that are separate) into the LC adapter ports at the rear of the
module (shown in
Figure 14 ). Fiber Channel 4 (A) (1550nm) is the top
cable from the SFP device and Fiber Channel 3 (B) (1570nm) is the
bottom cable.
Figure 14. F3 and F4 Fiber Cable Silkscreen Guide Detail
The fiber optic outputs from the rear module are shown in Figure 15 .
Figure 15. Fiber Optic Outputs
For the SFP device types and cabling examples used in this procedure, the
following frequencies should be output from this connector:
• Fiber Out 1 = 1610nm
• Fiber Out 2 = 1590nm
• Fiber Out 3 = 1570nm
• Fiber Out 4 = 1550nm
If you are using 8943CFs to multiplex 9 or 16 frequencies through the
8939FCA/FCB modules, the other 8943CFs should be equipped with the
SFP devices with the frequencies described in CWDM Configuration
on
page 25 .
Fiber 4
Fiber 3
Cable guide
B
A
OUT OUT
1
2 3
4