Grass Valley 8943CF User Manual
Page 15
8943CF — Instruction Manual
15
Installation
Installation of each SFP device involves three steps:
1.
Mount the metal bracket to the SFP device,
2.
Mount the SFP device and bracket on the front of the 8943CF front
module, and
3.
Install the fiber cable assembly to the SFP device and the rear fiber optic
LC adapter connectors.
CAUTION Use industry standard practice fiber optic cleaning and anti-static handling
procedures when installing and cabling the fiber optic devices or after any
de-mating cycle. Refer to Fiber Optic Cleaning Requirement
Mount Metal Bracket to SFP Device
Attach the mounting bracket to the SFP device as shown below.
1.
Insert the narrow end (SCA-2 connector) of the SFP device into the
mounting bracket, label side up with the open slots on the bracket
pointing to the rear as shown by the direction of the arrow in
Figure 4. Mounting Bracket
2.
Attach the mounting bracket to the SFP device by sliding the bottom
part of the bracket as far as it will go (
) on the bottom side of the
SFP device to hold it in place without forcing it. Make sure the open
bracket slots point towards the SCA-2 (electrical) connector on the SFP
device.
Figure 5. Attach Bottom of Bracket to SFP Device
V-connection
SCA-2 (electrical) connector