Grass Valley 8943CF - Manual (Page 32)

32 8943CF — Instruction Manual
Configuration and Monitoring
Auto Reclock/Mute Mode (Default)
In this mode, the electrical inputs are equalized and fed to the reclocker. If
the specific bit rates of 270Mb/s, 1485Mb/s, or 2970Mb/s are analyzed by
the module, it will reclock the signal at the determined bit rate and feed this
signal to both the electrical BNC and the fiber optic outputs. With input
reporting enabled, the input signal will be reported as
Present .
If the input signal is not 270Mb/s, 1485Mb/s, or 2970Mb/s, or the signal
input is not present, the output of the reclocker will be muted and the
outputs will be static (muted). With input reporting enabled, the input
signal will be reported as
Not Present .
3G 2970M Mode
In this mode, the electrical inputs are equalized and fed to the reclocker. If
the bit rate is analyzed as 2970Mb/s (3G), the module will reclock the signal
at the determined bit rate and feed this signal to both the electrical BNC and
the fiber optic outputs. With input reporting enabled, the input signal will
be reported as
Present .
If no input signal or a signal other than 2970Mb/s (3G) is detected by the
module, the output of the reclocker will be muted and the outputs will be
static (muted). With input reporting enabled, the signal input will be
reported as
Not Present .
HD 1485M Mode
In this mode, the electrical inputs are equalized and fed to the reclocker. If
the bit rate is analyzed as 1485Mb/s (HD), the module will reclock the
signal at the determined bit rate and feed this signal to both the electrical
BNC and the fiber optic outputs. With input reporting enabled, the input
signal will be reported as
Present .
If no input signal or a signal other than 1485Mb/s is detected by the
module, the output of the reclocker will be muted and the outputs will be
static (muted). With input reporting enabled, the signal input will be
reported as
Not Present .