Installing uam, Deploying uam subcomponents on the master server – H3C Technologies H3C Intelligent Management Center User Manual
Page 59

52
H3C recommends that you deploy all UAM subcomponents except EIP Sub Server and User Access
Management Sub Server as follows:
•
On networks with moderate traffic load, deploy these subcomponents only on a subordinate server.
•
On networks with high traffic load, deploy these subcomponents on the master server and a
subordinate server at the same time.
EIP Sub Server and User Access Management Sub Server can be deployed only on a subordinate server.
This example deploys EIP Sub Server and User Access Management Sub Server on a subordinate server
and other subcomponents on the master server.
Installing UAM
1.
Install IMC UAM on the master server in the same way IMC NTA is installed. (Details not shown.)
For information about the installation procedures, see "
."
2.
In the Installation Completed window (see
), select Open deployment monitoring agent
and click Finish.
Figure 41 Installation Completed
Deploying UAM subcomponents on the master server
1.
In the Installation Completed window (see
), select Open deployment monitoring agent
and click Finish.
The system automatically starts the Intelligent Deployment Monitoring Agent and displays the
Batch deploy window, as shown in
.