N in, Figure 53 – H3C Technologies H3C SecBlade IPS Cards User Manual

Page 78

Figure 53 OAA configuration

Table 8

describes OAA client configuration items.

Table 8 OAA client configuration items

Item Description

ACFP Client

Specify whether to enable ACFP client.
The ACFP client is enabled by default.

Username

Set the username of the OAA client. The username should be the same with the

related configuration of the SNMP on the OAA server.

Authentication Password

Encryption Password

Set the authentication password and encryption password for the OAA client.
Three security levels are available: no authentication no privacy, authentication

without privacy, and authentication with privacy. The security level you set should

be the same with the related configuration of the SNMP on the OAA server.

NOTE:

The switch supports MD5 authentication and DES encryption. To perform

authentication with privacy, configure MD5 authentication and DES encryption for the

SNMP configuration on the OAA server.

OAA Server IP

Set the IP address for the OAA server.

VLAN ID

Specify the VLAN to which the internal interface belongs.

IP Address

Set the IP address for the internal interface.

Subnet Mask

Set the subnet mask for the internal interface.

After configuring the OAA client, click Test Connectivity to test the connectivity between the OAA client

and the server.

NOTE:

By clicking Test Connectivity, you can use the configured parameters to test the connectivity between the
OAA client and the server. After the connectivity test succeeds, click Apply to submit your configuration.