H3C Technologies H3C SecBlade IPS Cards - Manual (Page 13)

6
Login
With the web network management function, the administrator can manage and maintain a SecBlade
IPS card through the web interface.
Follow these steps to log in to the web interface of the SecBlade IPS card.
1. Connect the SecBlade IPS card to a PC
• For the LSWM1IPS10 card
Prepare a console cable with a RJ 45 connector at one end and a DB9 female connector at the other.
Connect the RJ 45 connector to the console port of the switch, and connect the DB9 female connector to
the serial port of the PC. Then connect the management port of the SecBlade IPS card to the network
interface of the PC by using a crossover Ethernet cable.
Figure 1 Connect the SecBlade IPS card to a PC
PC Switch & IPS card
Console cable
Ethernet cable
Serial interface
Ethernet interface
Management interface
(IPS card)
Console interface
(Switch)
• For a non-LSWM1IPS10 card
Prepare a console cable with a RJ 45 connector at one end and a DB9 female connector at the other.
Connect the RJ 45 connector to the console port of the SecBlade IPS card, and connect the DB9 female
connector to the serial port of the PC. Then connect the management port of the SecBlade IPS card to the
network interface of the PC by using a crossover Ethernet cable.
Figure 2 Connect the SecBlade IPS card to a PC
2. Set terminal parameters on the PC
Run the terminal emulator on the PC (for example, Terminal of Windows 3.X, hyper terminal of Windows
9X and Windows XP).
Set the bits per second to 9600, data bits to 8, parity to none, stop bits to 1, and flow control to none,.
NOTE:
Settings of terminal parameters depend on the device model.