H3C Technologies H3C SecBlade IPS Cards - Manual (Page 65)

58
# Save the configurations.
save
NOTE:
Make sure that the OAA card in slot n corresponds to the router’s internal interface Ten-GigabitEthernet
n/0/0. For example, the OAA card in slot 5 corresponds to the router’s internal interface
Ten-GigabitEthernet 5/0/0.
2. Configure the SecBlade IPS card
# Configure an IP address for the management interface and enable the management interface. This
configuration is optional. By default, the IP address of the management interface is 192.168.1.1. You can
also change this IP address through the web interface.
system-view
[Sysname] interface meth0/2
[Sysname-if]ip address 192.168.0.11 255.255.255.0
[Sysname-if] undo shutdown
[Sysname-if] quit
# Log in to the web interface of the SecBlade IPS card. The username and password are both admin.
Figure 39 Log into the SecBlade IPS card
# Configure OAA.
• Configure the OAA client and the internal interface and test the connectivity between the OAA
client and the router.