H3C Technologies H3C SecBlade IPS Cards - Manual (Page 15)

8
Figure 3 web interface login interface
By default, the IPS card has HTTPS enabled, but does not have HTTP enabled. Therefore, for the first login,
only the HTTPS method is available. After the first login through HTTPS, you can enable HTTP as follows:
select System Management > Network Management > Management Interface from the navigation tree
to enter the page shown in
Figure 4 .
Figure 4 HTTP/HTTPS configuration
Select the checkbox before HTTP and click Apply. A confirmation dialog box pops up, showing
“Changing the IP address of the management interface may break the network connection. Continue?”.
Click OK on the dialog box to complete configuration.
WARNING!
•
The PC in Figure 2 is a common configuration terminal and is not required to be a web network
management terminal.
• Do not log in to the web interface through both HTTP and HTTPS at the same time from a PC.
After the first login, H3C recommends changing the default password. For more information, see User
Management in the H3C Intrusion Prevention System Web-Based Configuration Guide.