H3C Technologies H3C SecBlade IPS Cards - Manual (Page 54)

47
To do… Use the command… Remarks
Create a VLAN and
enter VLAN view vlan { vlan-id1 [ to vlan-id2 ] |
all }
Required
Return to system view quit Required
Enter the specified
VLAN interface view interface Vlan-interface
vlan-interface-id
Required
Before creating the VLAN interface,
you need to create the corresponding
VLAN. Otherwise, the VLAN
interface cannot be created.
Configure an IP address
and mask for the VLAN
interface
ip address ip-address { mask |
mask-length } [ sub ] Required
Not configured by default.
Enable the VLAN
interface
undo shutdown
Required
By default, the VLAN interfaces on an
S12500 switch are down.
Return to system view quit Required
Enter the view of the
10GE interface
connected to the
SecBlade IPS card
interface Ten-GigabitEthernet
interface-number
Required
Configure the link type
of the interface port link-type { access |
hybrid | trunk }
Required
By default, the link type of an
interface is access.
Specify permitted
VLANs on the trunk port port trunk permit vlan
{ vlan-id-list | all }
Required
A trunk port can allow packets of
multiple VLANs to pass. If you use the
command repeatedly on the
interface, all the specified VLANs are
permitted.
Configure the extended
port connection mode
for the trunk port
port connection-mode extend Required
Disable MAC address
learning on the 10GE
interface
mac-address max-mac-count
0
Required
Enable the Ethernet
interface
undo shutdown
Required
By default, Ethernet interfaces on an
S21500 switch are down.
Configure
the
internal
10GE
interface
Return to system view quit Required
Save all configurations save [ file-name | [ safely ] Required
Configuring the SecBlade IPS card
Configure the SecBlade IPS card as follows.
• Configure the IP address of the management interface at the CLI and use the IP address to login to
the web interface of the SecBlade IPS card.