H3C Technologies H3C SecBlade IPS Cards User Manual
Page 22
15
•
Configure the link type of the internal interface as access, add it to VLAN 100, which must be
consistent with the VLAN ID configured on the OAA configuration page of the SecBlade IPS card,
and configure its port-connect-mode as extended.
[Sysname] interface Ten-GigabitEthernet1/3/1
[Sysname-Ten-GigabitEthernet] port access vlan 100
[Sysname-Ten-GigabitEthernet] port connection-mode extend
[Sysname-Ten-GigabitEthernet] quit
# Save the configuration.
NOTE:
Make sure that the OAA card in sub-slot m of slot n corresponds to the switch’s internal interface
Ten-GigabitEthernet n/m/1. For example, the OAA card in sub-slot 3 of slot 1 corresponds to the switch’s
internal interface Ten-GigabitEthernet 1/3/1.
2.
Configure the SecBlade IPS card
# Configure an IP address for the management interface and enable the management interface. This
configuration is optional. By default, the IP address of the management interface is 192.168.1.1. You can
also change this IP address through the web interface.
[Sysname] interface meth0/0
[Sysname-if]ip address 192.168.0.11 255.255.255.0
[Sysname-if] undo shutdown
[Sysname-if] quit
# Log in to the web interface of the SecBlade IPS card. The username and password are both admin.
Figure 6 Log into the SecBlade IPS card
# Configure OAA.
•
Configure the OAA client and the internal interface and test the connectivity to the switch.