H3C Technologies H3C SecBlade IPS Cards User Manual
Page 41
34
[Sysname-GigabitEthernet3/1/1] quit
[Sysname] interface GigabitEthernet4/1/1
[Sysname-GigabitEthernet4/1/1] packet-filter inbound link-group 4000
[Sysname-GigabitEthernet4/1/1] quit
2.
Configure the SecBlade IPS cards
# Configure an IP address for the management interface and enable the management interface. This
configuration is optional. By default, the IP address of the management interface is 192.168.1.1. You can
also change this IP address through the web interface.
[Sysname] interface meth0/2
[Sysname-if]ip address 192.168.0.21 255.255.255.0
[Sysname-if] undo shutdown
[Sysname-if] quit
# Log in to the web interface of the SecBlade IPS cards using default user name admin and default
password admin.
Figure 20 Log in to the SecBlade IPS card web interface
# Select System Management > Network Management > Interface Swap Table Configuration. Click Add
Interface Swap Entry. Select 0 for Index, and xeth0/0 for Interface 1 and Interface 2, and click Apply
& Activate, as shown in
Figure 21 Interface swap table configuration for the SecBlade IPS cards