H3C Technologies H3C SecBlade IPS Cards User Manual
Page 14
7
3.
Enter the CLI of the device
•
For the LSWM1IPS10 card
Power on the switch. As the S5800 and S5820X are centralized stacking devices, you need to execute
the command for logging into the OAP system before you can enter the CLI of the LSWM1IPS10 card.
# Enter the CLI of the LSWM1IPS10 card.
Press CTRL+K to quit.
Connected to SubSlot3!
The PC then displays the Power On Self Test (POST) information of the IPS card. After the POST, you are
prompted to enter the password (the default password is H3C, which is case-sensitive). Enter the correct
password to enter the CLI of the IPS card.
•
For a non-LSWM1IPS10 card
Power on the switch or router. The PC shows the POST information of the IPS card. After the POST, you are
prompted to enter the system password, which defaults to H3C (case-sensitive). After you input the
correct password, you can enter the CLI of the IPS card.
4.
Configure the management IP address of the IPS card (this step is optional; the default
management IP address is 192.168.1.1).
# Configure the management IP address of the IPS card (The default management interface of
LSWM1IPS10 card is meth 0/0, and that of other cards is meth 0/2. The following takes management
interface meth0/2 as an example.)
[Sysname] interface meth0/2
←Enter the management interface
[Sysname-if] ip address 10.153.17.82 255.255.255.0
←Configure the IP address and mask of
the management interface as 10.153.17.82/24
[Sysname-if] undo shutdown
←Enable the management interface
The system automatically saves the above configuration.
5.
Configure an IP address for the PC to ensure connectivity with the SecBlade IPS card.
Configure an IP address in the subnet 10.153.17.0/24 (except for 10.153.17.82), for example,
10.153.17.83.
6.
Open the browser to login
Open the IE browser on the PC, and input the IP address 10.153.17.82 to enter the login interface shown
in
.
On the login interface, input the default user name admin and the default password admin, and click
Login to log in to the device through the web interface.