H3C Technologies H3C SecBlade IPS Cards - Manual (Page 66)

59
Figure 40 Configure the OAA client
After completing configuration, click Test Connectivity. If the following message appears, the router is
reachable.
Figure 41 Connectivity test result
# Configure security zones.
After completing OAA configuration on the SecBlade IPS card and the router, you can add any physical
ports of the router except the internal interface to a security zone.
In this example, create internal security zone Inside and add GigabitEthernet 3/0/0 to the internal zone,
as shown in
Figure 42 . Create external zone Outside and add GigabitEthernet 3/0/1 to the external
zone in the same way.
Figure 42 Create a security zone
# Configure a segment.