H3C Technologies H3C SecBlade IPS Cards - Manual (Page 52)

45
4. The switch forwards the packets out its internal network interface.
Configuration Procedure
Configuring the switch
Configure the switch as follows.
• Configure the MIB style of the switch.
• Configure SNMP parameters.
• Enable the ACFP server and the ACSEI server.
• Configure a VLAN, VLAN 100, for example, which must not conflict with any existing VLANs on the
switch, and configure an IP address for the VLAN interface.
• Configure the internal 10GE interface as a trunk interface, assign it to all VLANs, and configure its
connection mode as extended.
• Disable MAC address learning on the internal interface.
• Save the configuration and reboot the switch.
Follow these steps to configure the switch:
To do… Use the command… Remarks
Enter system view system-view —
Configure the MIB style of the switch mib-style [ new | compatible ]
Required
• new: Specifies the MIB style H3C
new. With this style, both the
sysOID and private MIB of the
switch are located under the H3C
enterprise ID 25506.
• compatible: Specifies the MIB
style H3C compatible. With this
style, the sysOID of the switch is
located under the H3C enterprise
ID 25506, and the private MIB is
located under the enterprise ID
2011.
By default, the MIB style of the switch
is new.
You need to reboot the switch to
validate this configuration (you can
reboot the switch after completing all
configurations).
CAUTION:
Make sure that the switch’s the MIB
style is new. If you specify compatible
for the switch, the switch cannot work
normally.
Enable SNMP agent snmp-agent
Required
Disabled by default.