Configuration procedure – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual
Page 83
10-15
Configuration procedure
1) Configuration on the fat AP
# Create a WLAN-ESS interface.
[AP] interface WLAN-BSS 1
[AP-WLAN-BSS1] quit
# Configure a clear-type service template, and configure its SSID as service, specify the open-system
authentication mode, and enable the WLAN service template.
[AP] wlan service-template 1 clear
[AP-wlan-st-1] ssid service
[AP-wlan-st-1] authentication-method open-system
[AP-wlan-st-1] service-template enable
[AP-wlan-st-1] quit
# Configure the bandwidth as 40 MHz, and bind WLAN-Radio 1/0/1 to service template 1 and
WLAN-BSS 1.
[AP] interface WLAN-Radio 1/0/1
[AP-WLAN-Radio1/0/1] radio-type dot11gn
[AP-WLAN-Radio1/0/1] channel 6
[AP-WLAN-Radio1/0/1] channel band-width 40
[AP-WLAN-Radio1/0/1] service-template 1 interface WLAN-BSS 1
2) Configuration
verification
z
The clients can associate with the APs and access the WLAN.
z
You can use the display wlan client and display connection commands to view the online
clients. The 802.11n client information is displayed in the output information of the display wlan
client command.