beautypg.com

Mapping a mesh profile to the radio of an mp, Mapping an mp policy to the radio of an mp, Mapping a mesh profile to the radio of an mp -5 – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 65: Mapping an mp policy to the radio of an mp -5

background image

9-5

To do…

Use the command…

Remarks

Configure the link saturation RSSI

link-saturation-rssi value

Optional

100 dBm by default

Configure the probe request
interval

probe-request-interval
interval-value

Optional

By default, the probe request interval is
1000 ms.

Configure the link rate mode

link rate-mode { fixed |
real-time
}

Optional

The default link rate mode is fixed.

Mapping a Mesh Profile to the Radio of an MP

To enable a WDS service, a mesh profile must be mapped to the radio of the MP.

Follow these steps to map a mesh profile to a radio:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter radio interface view

interface wlan-radio interface-number

Map the mesh profile to the
radio interface

mesh-profile mesh-profile-number

Required

By default, no mesh profile is
mapped to the radio.

z

The WLAN mesh interface of the MP will be created if the MP is in running state and the mapped

mesh profile is enabled.

z

You need to manually specify the working channels of the radios on the two APs for which a WDS

link is to be established, and the working channels must be the same.

Mapping an MP Policy to the Radio of an MP

An MP policy should be mapped to a radio so that link formation and maintenance on the radio can be

driven by the attributes specified in the MP policy.

Follow these steps to map an MP policy to the radio:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter radio interface view

interface wlan-radio
interface-number

Map the MP policy to the
radio

mp-policy my-policy-name

Required

By default, the default MP policy
“default_mp_plcy” is adopted for the radio.

This manual is related to the following products: