beautypg.com

Specifying a peer mac address on the radio, Displaying and maintaining wds, Wds configuration examples – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 66: Wds point to point configuration example, Network requirements, Specifying a peer mac address on the radio -6, Wds point to point configuration example -6

background image

9-6

Specifying a Peer MAC Address on the Radio

You need to specify the MAC addresses of allowed peers on the local radio interface.

Follow these steps to specify a peer MAC address on a radio interface:

To do…

Use the command…

Remarks

Enter system view

system-view

Enter radio interface view

interface wlan-radio interface-number

Specify the MAC address
of a permitted peer

mesh peer-mac-address mac-address

Optional

By default, the radio has no peer
MAC address configured, and thus
all neighbors are permitted.

Displaying and Maintaining WDS

To do…

Use the command…

Remarks

Display WDS link
information

display wlan mesh-link { mesh-profile
mesh-profile-number | radio radio-number |
peer-mac-address mac-address | all }

Available in any view

Display mesh profile
information

display wlan mesh-profile
{ mesh-profile-number | all }

Available in any view

Display MP policy
information

display wlan mp-policy { mp-policy-name |
all }

Available in any view

WDS Configuration Examples

WDS Point to Point Configuration Example

Network requirements

In an outdoor environment as shown in

Figure 9-4

, connecting the two LAN segments with cables is

time-consuming and cost ineffective. Therefore, you can connect the two LAN segments with a WDS

link. More specifically:

z

Connect AP 1 and AP 2 to different LAN segments.

z

Configure AP 1 and AP 2 to use channel 153 to establish the 802.11a WDS link.

z

Configure preshared key 12345678 to ensure WDS link security.

This manual is related to the following products: