beautypg.com

Configuration procedure – H3C Technologies H3C WA2600 Series WLAN Access Points User Manual

Page 67

background image

9-7

Figure 9-4 WDS point to point configuration

AP 2

AP 1

LAN Segment 2

LAN Segment 1

Configuration procedure

Because the WDS point to point configuration made on the two APs are similar, the following only gives

the configuration on AP 1.

# Enable port security.

system-view

[AP1] port-security enable

# Configure the port mode as psk, configure a PSK key of 12345678, and configure 11key negotiation.

[AP1] interface WLAN-MESH 1

[AP1-WLAN-MESH1] port-security port-mode psk

[AP1-WLAN-MESH1] port-security preshared-key pass-phrase simple 12345678

[AP1-WLAN-MESH1] port-security tx-key-type 11key

[AP1-WLAN-MESH1] quit

# Configure the mesh profile, specify the mesh ID of the current mesh profile as outdoor, bind

WLAN-Mesh 1 to the service template, and enable the current mesh profile.

[AP1] wlan mesh-profile 1

[AP1-wlan-mshp-1] mesh-id outdoor

[AP1-wlan-mshp-1] bind WLAN-MESH 1

[AP1-wlan-mshp-1] mesh-profile enable

[AP1-wlan-mshp-1] quit

# Enter the radio interface view and specify the working channel as 153.

[AP1] interface WLAN-Radio 1/0/1

[AP1-WLAN-Radio1/0/1] radio-type dot11a

[AP1-WLAN-Radio1/0/1] channel 153

Configure the same working channel for AP 1 and AP 2, that is, if you select channel 153 as the WDS

channel for AP 1, you need to also select the same channel for AP 2.

# Configure the peer MAC address on the radio interface, namely, the MAC address of the radio

interface on AP 2.

[AP1-WLAN-Radio1/0/1] mesh peer-mac-address 0ebb-01bb-bb00

# Map the mesh profile to the radio interface.

This manual is related to the following products: