H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 50)

39
Feature Reference
802.1X 802.1X in Security Configuration Guide
Ports specified as source interfaces
in portal-free rules
Portal in Security Configuration Guide
Configuring a static aggregation group
To guarantee a successful static aggregation, make sure that the ports at both ends of each link are in the
same aggregation state.
Configuring a Layer 2 static aggregation group
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
interface bridge-aggregation
interface-number
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
3. Exit to system view. quit N/A
4. Assign a Layer 2 Ethernet
interface to the aggregation
group.
a. interface interface-type
interface-number
b. port link-aggregation
group number
Repeat this step to assign more
Layer 2 Ethernet interfaces to the
aggregation group.
5. Assign the port an
aggregation priority. link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port might affect the
aggregation state of the ports in
the static aggregation group.
Configuring a dynamic aggregation group
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated
at one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Configuring a Layer 2 dynamic aggregation group
Step Command Remarks
1. Enter system view. system-view N/A