H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 31)

20
Configuration guidelines
When you bulk configure interfaces in interface range view, follow these restrictions and guidelines:
• In interface range view, only the commands supported by the first interface are available.
• Do not assign an aggregate interface and any of its member interfaces to an interface range at the
same time. Some commands, after being executed on both an aggregate interface and its member
interfaces, can break up the aggregation.
• No limit is set on the maximum number of interfaces in an interface range. The more interfaces in
an interface range, the longer the command execution time.
Configuration procedure
To bulk configure interfaces:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface range view.
• interface range interface-list
• interface range name name
[ interface interface-list ]
Use either command.
With the interface range name
command, you assign a name to an
interface range and can specify this
name rather than the interface range to
enter the interface range view.
3. Display commands
available for the first
interface in the interface
range.
Enter ? at the interface range
prompt.
Optional.
4. Execute available
commands to configure
the interfaces.
Available commands vary by
interface.
N/A
5. Verify the configuration. display this Optional.