H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 127)

116
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view or
port group view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregation
interface view:
interface
bridge-aggregation
interface-number
• Enter port group view:
port-group manual
port-group-name
Use one of the commands.
• The configuration made in Layer 2
Ethernet interface view applies only to the
port.
• The configuration made in port group
view applies to all ports in the port group.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
3. Configure the link type of
the ports as access.
port link-type access
Optional.
By default, all ports are access ports.
4. Assign the access ports
to a VLAN.
port access vlan vlan-id
Optional.
By default, all access ports belong to VLAN
1.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view.
Configuration restrictions and guidelines
• To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link
type to access first.
• After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to
configure the trunk port to allow packets from the PVID to pass through, so that the egress port can
forward packets from the PVID.
Configuration procedure
To assign a trunk port to one or multiple VLANs:
Step Command Remarks
1. Enter system view. system-view N/A